Now proceed with the home button flex replacement. 4. After replacing the flex cable, connect the phone to computer, open iTunes, run a backup first then click "Restore Firmware" (not restore from backup). Note that all data will be wiped out on your phone and it will be upgraded to the latest firmware. 5. User526 Said: "Face ID not working after 17.1.1 update: Face ID stopped working on iPhone 12 after 17.1.1 software update" Troubleshooting Face ID: There are know stand alone updates for Face ID that I am aware of.
Updates rarely if ever cause Face ID to stop working. Hardware issues do however. You should schedule an appointment at your Apple Store Genius Bar (if you haven't had your screen replaced on your iPhone by anyone other than Apple or an Apple Authorized Service Provider) to have your phone evaluated. ( 0) Reply.
Options. Hi Elie. The Face ID feature on the iPhone X works with sensors located within the frame and connected directly to the screen. Chances are the sensors connected on the screen were affected during your screen replacement. You should check the flex cable all the way on top of the screen for: connection (plugged into the board all the way)
Yes, Face ID can be fixed after a screen replacement. This requires a reset of the Face ID system, which can be done at an Apple Store, an Apple-authorized repair shop, or at home. At an Apple Store, simply turn off Face ID in the Settings, then go to the Genius Bar to reset it. At an Apple-authorized repair shop, they should reset Face ID as

The iPhone X shows an alert that says it is ‘unable to activate Face ID on this iPhone’. Also, according to the feedback from our client, Face ID on the phone is available after being dropped. However, Face ID is not available after replacing of the display assembly. Diagnosis: 1. Check the Infrared camera and dot projector module under

1 Answer. With the Face ID on iPhones, the front speaker flex cable is linked to the logic board so as long as you transfer this part over you shouldn’t have an issue. By taking the flex off I would recommend a fair amount of heat and it can also help to use Isopropyl alcohol to soften the adhesive and take it slowly if it is your first time.

If you didn’t remove the parts before attempting the glass replacement they have probably become damaged. For someone who doesn’t do this for a living I would suggest you should have removed the: · Screen. · Logic board. · Rear cameras. · Front cameras. · Charging dock. The iPhone X has a lot of parts which have sensors.
Review this guide published by Apple ️ If Face ID isn’t working on your iPhone. If the above does not help then take your iPhone back to the shop that replaced the screen on your iPhone because it may not have been installed correctly. Axel F. Reply. Helpful.
6GiX6Ki.
  • nza3q3wcj6.pages.dev/927
  • nza3q3wcj6.pages.dev/471
  • nza3q3wcj6.pages.dev/175
  • nza3q3wcj6.pages.dev/997
  • nza3q3wcj6.pages.dev/48
  • nza3q3wcj6.pages.dev/260
  • nza3q3wcj6.pages.dev/462
  • nza3q3wcj6.pages.dev/348
  • nza3q3wcj6.pages.dev/952
  • nza3q3wcj6.pages.dev/872
  • nza3q3wcj6.pages.dev/486
  • nza3q3wcj6.pages.dev/853
  • nza3q3wcj6.pages.dev/7
  • nza3q3wcj6.pages.dev/885
  • nza3q3wcj6.pages.dev/913

    • iphone 11 face id not working after screen replacement